This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. • To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.• The AC/DC adapter is used as disconnect device. The AC/DC adapter of apparatus should not be obstructed OR
should be easily accessed during intended used. To be completely disconnect the power input , the AC/DC adapter
of apparatus should be disconnected from the mains. • Minimum 10 cm (4 inches) distances around the apparatus for sufficient ventilation. • Battery- shall not be exposed to excessive heat such as sunshine, fire or the like.• The ventilation should not be impeded by covering the ventilation openings with items such as newspaper, table-
cloths, curtains etc. • No naked flame sources such as lighted candles should be placed on the apparatus.• The AC/DC adapter and apparatus shall not be exposed to dripping or splashing and that no objects filled with
liquids, such as vases, shall be placed on AC/DC adapter and apparatus. Never use the unit where it would be subject to: - Heat sources such as radiators or air ducts. - Direct sunlight. - Excessive dust. - Moisture or rain. - Mechanical vibration or shock. - Uneven surface. • Do not place any heavy objects on top of the unit.• When the unit is used with an AC power adapter, do not wrap the unit in a cloth, blanket, etc.. If you do so, the
temperature inside and outside the unit may rise considerably, resulting in malfunctioning of the unit.
• If the unit is brought directly from a cold to a warm location, or is placed in a very damp room, the moisture
may condense on the lens inside the unit. Should this occur, the unit will not operate. In this case, remove the
disc and leave the unit in a warm place for several hours until the moisture evaporates.• For the unit to operate at its best, it should not be subject to temperatures below 41°F (5°C) or above 95°F